PWM UNIPOLAR BUILDING DESIGN FOR CONTROLLING H-BRIDGE CIRCUITS USING OPERATIONAL AMPLIFIER
DOI:
https://doi.org/10.33019/ecotipe.v1i1.39Keywords:
Unipolar PWM, H-Bridge, OP-Amp, Triangular Wave, Voltage ControlAbstract
Unipolar PWM control technique carried out by comparing triangular wave with two control voltages. The resulting pulses are used to control H-Bridge circuit. The technique can be done by using the functions of the operational amplifier. There are three main circuits needed is a triangular wave circuit, voltage control circuit, and a comparator circuit. With proper adjustment between the triangular waves and voltage control, voltage regulation will be obtained smooth.
Downloads
Download data is not yet available.
Downloads
Published
30.04.2014
Issue
Section
Articles
License
Copyright in each article is the property of the author.
- The author acknowledges that the Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering) has the right to publish for the first time with a Creative Commons Attribution 4.0 International License.
- The author can enter the writing separately, regulate the non-exculsive distribution of manuscripts that have been published in this journal into other versions (for example: sent to the author's institution respository, publication into books, etc.), by acknowledging that the manuscript was first published in the Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering);
How to Cite
[1]
A. Asmar, “PWM UNIPOLAR BUILDING DESIGN FOR CONTROLLING H-BRIDGE CIRCUITS USING OPERATIONAL AMPLIFIER”, JurnalEcotipe, vol. 1, no. 1, pp. 1–4, Apr. 2014, doi: 10.33019/ecotipe.v1i1.39.
