ANALISA PENGARUH INTERFERENSI TERHADAP AVAILABILITY PADA JARINGAN TRANSMISI MICROWAVE MENGGUNAKAN SOFTWARE PATHLOSS 5.0 STUDI KASUS DI PT. ALITA PRAYA MITRA

Alfin Hikmaturokhman; Eka Wahyudi; Hendri Sulaiman

doi:10.33019/ecotipe.v1i2.47

ANALYSIS OF INTERFERENCE EFFECT ON AVAILABILITY ON MICROWAVE TRANSMISSION NETWORK USING PATHLOSS SOFTWARE 5.0 CASE STUDY IN PT. ALITA PRAYA PARTNER

Authors

Alfin Hikmaturokhman Telecommunication Engineering Study Program, Telkom Institute of Technology Purwokerto , Program Studi Teknik Telekomunikasi,Institut Teknologi Telkom Purwokerto
Eka Wahyudi Telecommunication Engineering Study Program, Telkom Institute of Technology Purwokerto , Program Studi Teknik Telekomunikasi,Institut Teknologi Telkom Purwokerto
Hendri Sulaiman Telecommunication Engineering Study Program, Telkom Institute of Technology Purwokerto , Program Studi Teknik Telekomunikasi,Institut Teknologi Telkom Purwokerto

DOI:

https://doi.org/10.33019/ecotipe.v1i2.47

Keywords:

Availability, Microwave, pathloss 5.0, link, Attenuation effects , Interference

Abstract

In doing microwave transmission interference and attenuation effects , not so much propagation Line Of Sight. Therefore it takes a computation and checking of a transmission network that values of interference does not greatly effect the availability value is supposed to be, there are several ways to avoid or even eliminate interference case is to replace the sub-band and change the polarization of the antenna system microwae. On the transmission network owned by Axiata PT.XL Banten there is a case of interference, namely the link Panimbang Hop-Labuan-Cigeulis due to using the same frequency and the same sub-band. RF Scanning seen from the results that the link is indeed indicated interference. Therefore, by using software pathloss 5.0 will be able to do an analysis of a link or network terinterferensi. so as to reduce and resolve a case interference occurs, and the value of a link availability can be well worth it. Optimization is done there will be a change of the ODU or replace the antenna polarization between vertical or horizontal. Optimization to do is replacing frequency channel that was using 1h (high) - 1l (low) the frequency is 7747.70 MHz-8059, 02 MHz, to frequency channel 3h (high) - 3l (low) the frequency is 7807.00 MHz-8118.32 MH. By doing this method interference value will be lost. Then after the optimization of the value of availability to 99.99993%.

Downloads

Download data is not yet available.

Downloads

PDF (Indonesian)

Published

30.04.2014

Issue

Vol. 1 No. 2 (2014): Jurnal Ecotipe, October 2014

Section

Articles

License

The author acknowledges that the Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering) has the right to publish for the first time with a Creative Commons Attribution 4.0 International License.
The author can enter the writing separately, regulate the non-exculsive distribution of manuscripts that have been published in this journal into other versions (for example: sent to the author's institution respository, publication into books, etc.), by acknowledging that the manuscript was first published in the Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering);

How to Cite

[1]

A. Hikmaturokhman, E. Wahyudi, and H. Sulaiman, “ANALYSIS OF INTERFERENCE EFFECT ON AVAILABILITY ON MICROWAVE TRANSMISSION NETWORK USING PATHLOSS SOFTWARE 5.0 CASE STUDY IN PT. ALITA PRAYA PARTNER”, JurnalEcotipe, vol. 1, no. 2, pp. 8–17, Apr. 2014, doi: 10.33019/ecotipe.v1i2.47.